Manual

VITEK Industrial Video Products
–
Transcendent Series NVRs
99
⑨ Click “Apply” to save the settings.
9.5 Abandoned/Missing Object Detection
① Click StartàSettingsàAI/EventàAI EventàObject Abandoned/Missing to go to the
following interface.
② Select the camera, enable the object detection, and set the duration and detect type. There
are two detection types: Abandoned object and missing object.
Abandoned object: Alarms will be triggered if there are articles left in the pre-defined detection
area.
Missing object: Alarms will be triggered if there are articles missing in the detection area drawn
by the users.
③ Select the alarm area and area name. A maximum of 4 alarm areas can be set.
④ Draw the alarm area of the object detection. Refer to the interface as shown above. Check
“Draw Area” and then click around the area where you want to set as the alarm area in the image
(the alarm area should be a closed area). Uncheck the “Draw Area” when you finish drawing.
Click “Clear” to delete the detection area.
⑤ Click “Trigger Mode” to configure abandoned/missing object detection alarm linkage items.
Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up
Video” and “E-mail”. The alarm linkage settings are the same as the face detection alarm (see
9.1.1 Face Detection Settings for details).
⑥ Click “Apply” to save the settings.
9.6 Crowd Density Detection
Only some IPCs may support this function.