Manual

VITEK Industrial Video Products
–
Transcendent Series NVRs
101
video by detecting, tracking, and counting the head shapes of people.
Note: Only some specific IPCs may support this function.
① Click StartàSettingsàAI/EventàAI EventàLine Crossing Counting to go to the
following interface.
② Select the camera, enable the line crossing people counting detection and set the duration,
sensitivity, statistic cycle, enter threshold, departure threshold and retention threshold.
Statistic cycle: Always, daily, weekly and monthly are optional.
Manual Reset: The current number of people counting will be cleared and the statistic cycle will
restart by clicking “Manual Reset” button.
③ Set the alarm area and entrance direction. Click “Draw Area” and drag the mouse to draw
a rectangle area. Drag the rectangle to change its position. Uncheck the “Draw Area” when
you finish drawing. Click “Clear” to clear the area. Click and drag the arrow or the other
end of the arrow line to change the people entrance direction.
⑥ Click “Apply” to save the settings.
l Line Crossing People/Vehicle/Non-Vehicle Counting
Only some IPCs support this function. If your camera does not support this function, please skip
the following instructions.
① Click StartàSetingsàAI/EventàAI EventàLine Crossing Counting to go to the following interface.
VITEK Industrial Video Products
–
Transcendent Series NVRs
102
② Enable line crossing counting.
③ Check “Draw line” and then drag the mouse on the small window to draw the crossing line.
Uncheck “Draw line” to finish the drawing. Click “Clear” to delete the alert line.
Direction: A->B and A<-B are optional. It is the crossing direction of the target that crosses over
the alert line.
④ Check “Statistical OSD”, the statistical information will be displayed on the live view
interface.
⑤ Set the reset information. You can set reset information manually or enable “Auto Reset” as
needed.
⑥ Click the “Detection Target” tab to set the detection target, including people, vehicle and
non-vehicle.
⑦ Click “Apply” to save the settings.
9.8 Exception Detection
Exception Detection Configuration:
① Click StartàSettingsàAI/EventàAI EventàException Detection to go to the following
interface.