Manual
VITEK Industrial Vide
o Products
–
Transcendent Series NVRs
127
② Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-
up Video” and “E-mail”. The alarm handling setting of motion alarm is similar to that of the
sensor alarm (see 11.1 Sensor Alarm for details).
③ Click “Apply” to save the settings. You can click “Motion Settings” to go to the motion
configuration interface.
11.3 Combination Alarm
① Click StartàSettingsàAlarm àCombination Alarm to go to the following interface.
② Customize combination alarm. Set alarm name and click “Configure” under the Combined
Alarm Configuration item. Then select alarm type and alarm source. Finally, click “OK” to save
the settings.
③ Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up
Video” and “E-mail”. The alarm handling setting of combination alarm is similar to that of the
sensor alarm (see 11.1 Sensor Alarm for details).
④ Click “Apply” to save the settings.
11.4 Exception Alarm
11.4.1 IPC Offline Settings
① Click StartàSettingsàAI/EventàIPC Offline Settings to go to the interface as shown
below.
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”,
“Pop-up Message Box” and “E-mail”. The IPC Offline Settings are similar to that of the sensor
alarm (see 11.1 Sensor Alarm for details).
VITEK Industrial Vide
o Products
–
Transcendent Series NVRs
128
③ Click “Apply” to save the settings.
11.4.2 Exception Alarm Settings
① Click StartàSettingsàAI/EventàException Alarm to go to the interface as shown below.
② Enable or disable “Push”, “Alarm-out”, “Buzzer”, “Pop-up Message Box” and “E-mail”.
The exception handling settings are similar to that of the sensor alarm (see 11.1 Sensor Alarm
for details).
③ Click “Apply” to save the settings.
11.5 Alarm Event Notification
11.5.1 Alarm-out
① Click StartàSettingsàAl/EventàEvent Notification to go to the following interface.
② Set the delay time and the schedule of each alarm-out. You can click “Edit Schedules” to
edit the schedules (see 7.1.2 Schedule Settings for details).
③ Click “Apply” to save the settings. You can click “Test” to test the alarm output.