Manual

VITEK Industrial Video Products
–
Transcendent Series NVRs
143
Multiple Address Setting:
If “Multiple Address Setting” is selected, the IP addresses of the two Ethernet ports should be set
respectively. Refer to the picture as shown below.
Check “Obtain an IPv4 address automatically”, “Obtain an IPv6 address automatically” and
“Obtain DNS automatically” to get the network addresses automatically, or manually enter the
network addresses; select one Ethernet port as the default route and then click “Apply” to save
the settings.
VITEK Industrial Video Products
–
Transcendent Series NVRs
144
13.1.2 Port Configuration
Click StartàSettingsàNetworkàPort to go to the interface as shown below. Enter the HTTP
port, HTTPS port, server port and POS port of the NVR, and then click “Apply” to save the
settings. You can also enable and set RTSP port (please check “Anonymous” as required).
HTTP Port: the default HTTP port of the NVR is 80. The port number can be changed to others
like 81. The port is mainly used to web client access. If you want to access the NVR through a
web browser, you should enter IP address plus HTTP port in the address bar of the web browser
like http://192.168.11.61:81.
HTTPS Port: the default HTTPs port of the NVR is 443.
HTTPs provides authentication of the web site and protects user privacy. How to use it?
① Enter IP address plus HTTP port in the address bar of the web browser. Then enter username
and password to log in. Click Functional PanelàNetworkàHTTPS to go to the following
interface.
② Install a certificate.
* You can create a private certificate here. Click the “Create” button to create a private certificate.
Enter the country (only two letters available), domain (NVR’s IP address/domain), validity date,
password, province/state, region and so on. Then click “OK” to save the settings.