Manual

VITEK Industrial Video Products
–
Transcendent Series NVRs
151
Protocol type and EAPOL version: Please use the default settings.
Username and password: The user name and password must be the same with the user name and
password applied for and registered in the authentication server.
13.1.8 NAT Configuration
Click StartàSettingsàNetworkàNAT to go to the interface for NAT configuration. Check
“Enable” and then select the NAT server address. Click “Apply” to save the settings.
You can scan the QRCode through mobile client which is installed in the mobile phone or tablet
to log in the mobile client instantly.
Access Type: NAT or NAT2.0 can be selected.
Note: if you want to use cloud upgrade, you must enable NAT2.0.
13.1.9 FTP Configuration
Some models may not support this function.
Click StartàSettingsàNetworkàFTP to go to the interface for FTP configuration. Check
“Enable” and enter the server name, port, username and password, max file size and remote
directory.
Please enable “Resume Uploading” as needed.
After that, you can choose the recorded files to upload as needed in this interface.
13.1.10 Platform Access
Some models may not support this function.
This function is mainly used for connecting VMS 2.0. The setting steps are as follows.
Click StartàSettingsàNetworkàPlatform Access to go to the interface.
VITEK Industrial Video Products
–
Transcendent Series NVRs
152
Platform Access
① Set “Access Type” as “Platform Software” and select “Enable” as shown below.
② Check the IP address and port of the transfer media server in the VMS 2.0. The default
server port for auto report is 2009. If it is modified, please go to the transfer media interface to
check.
③ Enable the auto report in the VMS 2.0 when adding a new device. Then self-define device
ID and complete the remaining information of the device in the VMS 2.0.
④ Enter the above-mentioned server address, port, and report ID in the server interface. Then
click “Apply” to save the settings. Now the VMS 2.0 system will automatically connect this
device.
UPnP Report Access
In this interface, you can also access the third-party platform by UPnP Report. If this one is
enabled, please enter the server address, port, and manufacturer ID.
13.1.11 SNMP
① Click StartàSettingsàNetworkàSNMP to go to the interface for SNMP configuration.