Manual

VITEK Industrial Video Products
–
Transcendent Series NVRs
159
14 Remote Surveillance
14.1 Mobile Client Surveillance
① Enable NAT in the NVR. Refer to 13.1.8 N AT Configuration for details.
② Download and install the mobile client “Transcendent viewer” into the mobile device with
a Android or iOS system.
③ Run the mobile client, go to the “Add Device” interface and then click to scan the
QRCode of the NVR (Go to StartàSettingsàSystemàInformationàBasic to view the QRCode
of the NVR).
④ After scanning the QRCode successfully, enter the login password to log in mobile client.
14.2 Web LAN Access
① Click StartàSettingsàNetworkàTCP/IP to go to the “TCP/IP” interface. Set the IP
address, subnet mask, gateway, preferred DNS, and alternate DNS of the NVR.
② Open IE browser on your computer, enter the IP address of the NVR in the address bar and
then press enter to go to the login interface as shown below. You can change the display language
on the top right corner of the login interface. Enter the username and password of the NVR in
the interface and then click “Login” to go to the live preview interface.
VITEK Industrial Video Products
–
Transcendent Series NVRs
160
14.3 Web WAN Access
Ø NAT Access
① Set the network of the NVR. Please refer to 13.1.1 TCP/IP Configuration for details.
② Enable NAT and then set the NAT server address. Please refer to 13.1.8 NAT Configuration
for details.
③ Open a web browser on your computer, enter the NAT server address www.autonat.com or
NVT2.0 server address www.natplus.top in the address bar and then press enter to go to the
interface as shown below (download and install the relative plugin according to the tip if you
access the NVR through NAT for the first time).
Notes: 1. Please make sure that the IP address of the NVR and the computer are both in the same local
network segment. For example, supposing that the IP address of the computer is 192.168.1.41,
the IP address of the NVR should be set to 192.168.1.XXX.
2. If the HTTP port of the NVR is not 80, but other number instead, you need to enter the IP
address plus port number in the address bar when accessing the NVR over network. For example,
the HTTP port is 81. You should enter http://192.168.1.42:81 in the address bar.