Manual

VITEK Industrial Video Products

–

Transcendent Series NVRs

3 Wizard & Main Interface

3.1 Startup Wizard

The disk icons will be shown on the top of the startup interface. You can view the number and

status of each disk quickly and conveniently through these icons ( : no disk; : unavailable

disk; : RW available disk).

You can quickly configure the DVR by the wizard setup to make the DVR work normally. You

must configure the wizard if you start the DVR for the first time (or click “Skip” to cancel the

wizard next time). Different versions have different wizard steps. The following wizard steps are

for reference only.

① Choose the language and locality as needed if it is the first time you use the wizard and then

read the privacy statement, checkmark “I have read and agree” and click “OK”.

② Date and Time Configuration. The date and time of the system needs to be set up if you

use the wizard for the first time. Refer to the following figure. Set the time zone, system time,

date format, time format and video format. The DST will be enabled by default if the time zone

selected includes DST. Click “Next” to continue.

③ System Login. Set your own password or use the default when you use the wizard for the

first time (the default username of the system is admin and the default password of admin is

123456); select the login username and enter the corresponding password next time.

VITEK Industrial Video Products

–

Transcendent Series NVRs

Enable pattern lock and click “Edit” to set the pattern lock.

Click “Next” to set questions and answers for password security of admin. If you forget the

password, please refer to Q4 in Appendix A FAQ for details.

Click “Next” to continue.

④ Disk Settings. You can view the disk number, disk capacity of the NVR and serial number,

R&W status of the disk. Click “Format” to format the disk. Click “Next” to continue. Then click

“Wizard Setup”.

⑤ Network Settings. Check “Obtain an IP address automatically” and “Obtain DNS

automatically” to get the IP address and DNS automatically (the DHCP function of the router in

the same LAN should also be enabled), or manually enter them. Enter the HTTP port, RTSP port

and Server port (please see 13.1.2 Port Configuration for details). Click “Next” to continue.