Manual

VITEK Industrial Video Products
–
Transcendent Series NVRs
21
Click to edit the searched IP camera as shown on the below left. Enter the new IP address,
subnet mask, gateway, username and the password of the camera. Click “OK” to save the settings.
Click to edit the added camera as shown on the above right. Enter the new camera name,
IP address, port, username and the password of the camera. You can check “Sync to IPC” to
modify the IP address of the IPC via different network segments for being in the same network
segment with the NVR. Then click “Test ” to test the connection. Click “OK” to save the settings.
You can change the IP camera name only when the added camera is online. Click “Next” to
continue.
Tips：Please skip Step ⑦ and ⑧ if the NVR does not support RAID function.
⑦ Disk Mode. Click “Enable RAID” to enable the RAID function. Click “Next” to continue.
⑧ Create an array. Set the array name and select array type which including RAID0, RAID1,
RAID5, RAID6 and RAID10. The global hot spares and array capacity can also be viewed here.