Manual
VITEK Industrial Video Products
–
Transcendent Series NVRs
21
Click to edit the searched IP camera as shown on the below left. Enter the new IP address,
subnet mask, gateway, username and the password of the camera. Click “OK” to save the settings.
Click to edit the added camera as shown on the above right. Enter the new camera name,
IP address, port, username and the password of the camera. You can check “Sync to IPC” to
modify the IP address of the IPC via different network segments for being in the same network
segment with the NVR. Then click “Test ” to test the connection. Click “OK” to save the settings.
You can change the IP camera name only when the added camera is online. Click “Next” to
continue.
Tips:Please skip Step ⑦ and ⑧ if the NVR does not support RAID function.
⑦ Disk Mode. Click “Enable RAID” to enable the RAID function. Click “Next” to continue.
⑧ Create an array. Set the array name and select array type which including RAID0, RAID1,
RAID5, RAID6 and RAID10. The global hot spares and array capacity can also be viewed here.
VITEK Industrial Video Products
–
Transcendent Series NVRs
22
See 7.4 Disk for details. Click “Next” to continue.
⑨ Record Settings. Two record modes are available: auto and customization.
Auto: Select one auto mode in the interface as shown below and then click the “Next” to save
the settings. Click “Advanced” to self-define record mode. See 7.1.1 Mode Configuration for
details.
Customization: Set the “Sensor Record”, “Motion Record”, “AI Record”, “POS Record” and
“Schedule Record” of each camera. Click “OK” to save the settings. See 7.1.1 Mode
Configuration for details.
⑩ QRCode. Enable the NAT or NAT2.0 function in the interface or set it in the network
configuration after exiting the wizard (please refer to 13.1.8 NAT Configuration for details). You
can scan the QRCode through the mobile client which is installed in the mobile phone or tablet
to log into the mobile client. Please refer to 14.1 Mobile Client Surveillance for details. Click
“OK”to save the settings.
⑪ Cloud Upgrade. Enable “Cloud Upgrade” and then click “OK” to save. If this function is
enabled, you can get the latest version from the cloud server. Please refer to 13.1.12 Cloud