Manual

VITEK Industrial Video Products
–
Transcendent Series NVRs
29
4 Camera Management
4.1 Add/Edit Camera
4.1.1 Add Camera
The network of the NVR should be set before adding IP camera (see 13.1.1 TCP/IP Configuration
for details).
Refer to the pictures below. Click Add Camera in the setup panel or in the top right corner
of the preview window to pop up the “Add Camera” window as shown below. You can quickly
add or add the IP camera manually.
Ø Quickly Add
Check the cameras and then click “Add” to add cameras. Click to edit the camera’s IP
address, username and password. Click “Default Password” to set the default username and
password of each camera.
VITEK Industrial Video Products
–
Transcendent Series NVRs
30
Ø Add Manually
Enter the IP address or domain name (click in the IP address column to pop up the domain
name input window, enter the domain name of the IPC in the window and then click “OK”), port,
username and password of the camera and then select the protocol. Click “Test” and then click
the “Add” button (you can input camera’s information or above such as IP address, username
and password before clicking the “Add” button). Click to delete the camera. Click “Default
Password” to set the default username and password of each camera.
Note: Some models may not support this function.
Click StartàSettingsàSystemàBasicàGeneral Settings to check “Enable Add IPC by Zero
Operation”. If the NVR has unoccupied channels, it can add IPC without any operation by
restarting.