Manual

VITEK Industrial Video Products
–
Transcendent Series NVRs
33
l The IP camera directly connected to the PoE port of the NVR through private protocol will
be shown automatically in the camera list.
l One of the two conditions must be met if the IP camera which is directly connected to the
PoE port of the NVR through ONVIF protocol should be shown automatically in the camera list.
ü The IP camera which is directly connected to the PoE port is in the same network
segment with the internal Ethernet port.
ü The DHCP (obtain an IP address automatically) of the IP camera which is directly
connected to the PoE port is enabled.
If the IP camera which is connected to the PoE port cannot be displayed automatically in the
camera list, please refer to Q6 in Appendix A FAQ for details.
4.2 Add/Edit Camera Group
4.2.1 Add Camera Group
Click “Edit Camera Group” in the above interface to go to the interface as shown below.
Click “Add Group” to pop-up the window as shown below. Set the group name and dwell time
(the dwell time of the camera group sequence view) in the window. Check the cameras and then
click “Add” to add group. Click to view the cameras in the group after adding group.