Manual

VITEK Industrial Video Products

–

Transcendent Series NVRs

5.4.2 Image Settings

Click StartàSettingsàCameraàImageàImage Settings to go to the following interface. Select

the camera and then set the brightness, contrast, saturation and hue of the camera. Click the

“Advanced” button or in the camera list on the right side of the interface to pop up the

“Image Adjust” interface and then set the relevant setting items. Please refer to 5.4.5 Image

Adjustment for detailed introductions of these items.

You can click “Default” to restore the image settings to the default factory settings.

5.4.3 Mask Settings

Some areas of the image can be masked for privacy. Up to four mask areas can be set for each

camera. Click StartàSettingsàCameraàImageàMask Settings to go to the interface as shown

below.

Select the camera and enable the mask. Click the “Draw” button and then drag the mouse on

the image area to set the mask area; click the “Delete” button to delete the mask areas; click

“Apply” to save the settings.

VITEK Industrial Video Products

–

Transcendent Series NVRs

5.4.4 Fisheye Settings

Some models may not support this function.

Click StartàSettingsàCameraàImageàFisheye Settings to go to the interface as shown below.

Select the camera and the mode of fisheye and installation.

5.4.5 Image Adjustment

Go to live preview interface and then click button on the tool bar under the camera window

to go to the image adjustment interface.

Ø Image Adjustment

Select the camera and then click “Image Adjustment” to go to image adjustment tab. Refer to the

above picture. Drag the slider to set the camera’s brightness, contrast, saturation and hue value.

Check sharpen, wide dynamic and denoise and then drag the slider to set the value. Click

“Default” to set these parameters to default values. The introductions of these parameters are as

follows: