Manual
VITEK Industrial Video Products
–
Transcendent Series NVRs
59
7 Record & Disk Management
7.1 Record Configuration
7.1.1 Mode Configuration
Please format the HDDs before recording (refer to 7.5 Disk Management for details). Click
StartàSettingsàRecordàMode Settings to go to the mode settings interface. You can set the
record time under the “Manual Record Settings” and then click “Apply” to save the settings.
There are two record modes: auto mode and manual mode.
Ø Auto Mode
Motion Record: Motion alarm record will be enabled when motion is detected.
Sensor Record: Sensor alarm record will be enabled when sensor alarm trips.
Motion Record+Sensor Record: Motion/sensor alarm record will be enabled when
motion/sensor alarm occurs.
Always(24
ⅹ
7) Record+Motion Record: Normal record is enabled all the time; motion alarm
record will be started when motion is detected.
Always(24
ⅹ
7) Record+Sensor Record: Normal record is enabled all the time; sensor alarm
record will be started when sensor alarm trips.
Always(24
ⅹ
7) Record+Motion Record+Sensor Record: Normal record is enabled all the time;
motion/sensor alarm record will be enabled when motion/sensor alarm occurs.
Always(24
ⅹ
7) Record+ Motion Record + Sensor Record + AI Record: Normal record is
enabled all the time; AI record will be enabled when AI event happens.
Yo u can add more auto modes on analytics record. Click “Advanced” to pop up a window as
shown below. Check the modes in the window and then click “Add” to show the modes in the
VITEK Industrial Video Products
–
Transcendent Series NVRs
60
record mode list (in the window, the checked modes can be shown in the record mode list while
the unchecked modes cannot.
Select one auto mode to pop up the corresponding window. Set the encode, G OP, resolution, FPS,
bitrate type, quality, max bitrate and audio of each camera and then click “OK” to save the
settings. Please adjust the parameters according to the actual condition.
Video Encode: the available options will be H.265S, H.265+, H.265, H.264S, H.264+ and H.264.
If the connected IP camera doesn’t support H.265s, H.265+, H.264S, H.264+, the corresponding
options will not be shown.
Resolution: the higher the resolution is, the clearer the image is.
FPS: the higher the frame rate is, the more fluid the video is. However, more storage will be
used.
Bitrate Type: CBR and VBR are options. CBR means that no matter how much change is seen
in the video scene, the compression bitrate will be kept constant. VBR means that the
compression bitrate will be adjusted according to scene changes. For example, for scenes that
do not have much movement, the bitrate will be kept at a lower value. This will help to
optimize the network bandwidth.
Quality: When VBR is selected, you need to choose image quality. The higher the image
quality you choose, the more bitrate will be required.
Max Bitrate: 32Kbps ~10240Kbps are options.
GOP: group of pictures.