Manual
VITEK Industrial Video Products
–
Transcendent Series NVRs
87
AI function also can be added and used to detect faces through NVR. But if face detection by
NVR is enabled for one camera (without AI), the people/vehicle perimeter detection cannot be
enabled simultaneously, and vice-versa.
③ Set the snapshot interval and snapshot number. The snapshot interval refers to the time
interval that the camera captures the same face during its continuous tracking period. The
snapshot number refers to the picture number of the same face captured during its continuous
tracking period (For example: the snapshot interval is set to “30 seconds” and the snapshot
number is set to “3”; then the camera will capture the same face once every 30 seconds and it
will capture this face 3 times at most during its continuous tracking period).
④ Enable face match exposure as need. When the brightness of the captured face is not enough,
it can be enabled. (Only some IPCs support this function)
⑤ Set the alarm area. Click “Draw” and then drag the mouse to draw a detection area. Click
“Clear” to delete the alarm area. Then set the detectable face size by defining the maximum value
and the minimum value (The default size range of a single face image occupies from 3% to 50%
of the entire image).
⑥ Enable “Save Source Information” or/and “Save Face Information” as needed. If enabled,
the system will automatically save the corresponding images on the SD card. For the models
with LED light, white light mode also can be set.
⑦ Click “Apply” to save the settings.
⑧ Click “Trigger Mode” to go to face detection alarm linkage setting interface: