Operation Manual

11
Setting Up the Remote Control
The remote control comes with one (1) 3V lithium battery
(CR2025). The battery is pre-installed in the remote control.
To begin using the remote control, remove the plastic tab (A)
from the battery compartment.
Replacing the Remote Control’s Battery
1
.
Remove the battery
compartment cover
by turning the cover
towards the arrow
(A). Then lift the
cover out towards
the arrow (B)..
2
.
Remove the old
battery and insert
the new battery
with the positive
side facing up.
3
.
Install the cover and turn
as shown in the illustration.
Caution:
1. Only use 3V lithium battery (CR2025).
2. Dispose of used batteries according to local ordinance regulations.
3. Remove the battery when not using Qumi for prolonged periods.
Operating Range
The remote control uses infrared (IR) transmission to control Qumi. It is necessary to
point the remote directly at Qumi.
The remote control functions properly within a radius of approximately 7 meters (23 feet)
and 15 degrees above or below the Qumi level (If the remote is not held perpendicular
to the sides or rear of Qumi).
If Qumi is unresponsive to the remote control, move closer towards Qumi.