Black Easel Studio TV Stand Instruction Manual SKU: STAND-TV65A Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-tv65a GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.
TOOLS NEEDED DO NOT EXCEED WEIGHT CAPACITY. Failure to do so may result in serious injury. 70.4lbs (32 kg) NORMAL FLOOR Phillips Screwdriver Drill 55 lbs (25 kg) GLOSSY FLOOR ASSEMBLY STEPS STEP 1 Screw side legs (A) and center leg (B) into base of pole (E). A E B A STEP 2 Adjust collar height using the 4mm Allen wrench (L). Recommended 50-150mm L NOTE: Please secure the locking collar before attaching the TV screen.
STEP 3 Remove screw from center clamp of lower VESA bracket (C) and open the clamp. C STEP 4 OPTION A: Flat Back Monitor Position VESA brackets horizontally on the back of the TV, making sure upper bracket (D) is on top and lower bracket (C) is below. Secure using screws (M-A or M-B) with square washers (M-F), with security clips (G) installed to top holes.
STEP 4 (Continued) OPTION B: Large or Curved Back Monitor Position VESA brackets horizontally on the back of the TV, making sure upper bracket (D) is on top and lower bracket (C) is below. Secure using screws (M-C, M-D or M-E) with square washers (M-F) and spacers (M-G, M-H) with security clips (G) installed to top holes.
STEP 5 Slide the TV with VESA brackets (C, D) onto pole (E). Close the clamp on lower VESA bracket over the pole and secure with previously removed screw. 1 2 3 STEP 6 Peel backing from cable clips (I) and install clips on rear leg. Use clips to organize cables. Optional: Secure cable clips using ST4.2x12 screws (J). Screws are able to thread directly into wood without drilling pilot holes.
STEP 7 Adjust TV to desired height, making sure the bottom edge of the TV does not contact the base of the pole. 1100mm ± 180° a STEP 8 Using Security Cable Clamps (H) as guides, mark drilling locations on wall. Drill holes at least 1.6” (40mm) deep using a 9/32” (7mm) drill bit. Insert anchors (N) into holes and mount clamps to wall using ST4.8x38 screws (M).
Love your new VIVO setup and want to share? Tag us in your photo! @vivo_us LAST UPDATED: 06/02/2020 Open Monday - Friday 7:00am - 7:00pm CST, our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product. help@vivo-us.com AVG.
