Music Mixer User Manual
46
12.8.1. Settings in adjustment mode
In the adjustment mode, audio setting parameters can be set while monitoring the output sound. Input and
output gain settings, input sound source equalization*, and sound equalization for individual output zones can
be performed.
Since the setting parameters are individually adjusted for each Event, perform Event settings in advance.
* Input sound source equalization can be performed only for channels equipped with the D-001T module.
The adjustment procedure is described here using an example when paging is made in Event 2 during BGM
broadcast in Event 1.
Step 1. Hold down the Utility menu key for 2 seconds or more in
normal operation state.
The setting screen is displayed.
Step 2. Select ADJUST with the Parameter setting knob.
The screen is switched to the adjustment mode.
Note
In the adjustment mode, the Event selected in normal
operation state continues to be broadcast.
Step 3. Press the Right shift key.
The Event selection screen is displayed.
Step 4. Using the Parameter setting knob, select the Event number,
then set the selected Event to ON by pressing the Input
channel ON/OFF key.
Note
The Event alternates between ON and OFF each time the
Input channel ON/OFF key is pressed.
Setting ON immediately activates the selected Event, and
OFF terminates it.
Step 5. Press the Right shift key.
The input gain setting screen is displayed.
To stop the audio output temporarily, press the input channel
ON/OFF key.
Step 6. Adjust the gain with the Input volume control.
Step 7. Press the Down shift key to display each input setting screen
and adjust on-screen parameters with the Parameter setting
knob.
When there are two or more setting items on the screen,
select the items with the Left and Right keys.
INPUT VOLUME
5
6
7
.
HPF – 400 HZ LPF– 12
5
I NPUT – SETT
I G
EVENT0 1 R
O
UT
EON
EVENT0 1 R
O
UT
EOF
F
UTILITY
ON/OFF
1
4
3
ADJ UST
IN1– IN1
ON
+10
.
:
IN1– IN1
ON
+05
.
:
PARAMETER
2
PARAMETER
12.8. Adjustment Mode Setting