Network Router User Manual

TL-R480T Enterprise Broadband Router User Giude
 Enable Firewall - The general firewall switch is on or off.
 Enable IP Address Filtering - Set IP Address Filtering is enabled or disabled.
There are two default filtering rules of IP Address Filtering, either Allow or Reny
passing through the router.
 Enable Domain Filtering - Set Domain Filtering as enabled or disabled.
 Enable MAC Filtering - Set MAC Address Filtering is enabled or disabled. You can
select the default filtering rules of MAC Address Filtering, either Allow or Reny
accessing the router.
5.7.2 IP Address Filtering
The IP Address Filtering feature allows you to control Internet Access by specific users
on your LAN based on their IP addresses. The IP Address Filtering are set on this page,
figure 5-23:
Figure 5-23 IP Address Filtering
To disable the IP Address Filtering feature, keep the default setting, Disabled. To set up
an IP Address Filtering entry, click Enable Firewall and Enable IP Address Filtering on
the Firewall page, and click the Add New… button. The page " Add or Modify an IP
Address Filtering entry " will appear shown in figure 5-24:
Figure 5-24 Add or Modify an IP Address Filtering Entry
To create or modify an IP Address Filtering entry, please follow these instructions:
- 30 -