Instructions

Avoid the following unfavourable ambient conditions at the installation point or
during transportation or storage:
- Dampness or excessive humidity
- Extreme cold or heat
- Direct sunlight
- Dust or ammable gasses, fumes or solvents
- Strong vibrations
- Strong magnetic elds such as those found in the vicinity of machinery or
loudspeakers
Do not operate the device in environments where there are high levels of dust,
ammable gases, vapours or solvents. There is a danger of re and explosion!
Ensure that the rechargeable battery is ventilated adequately at the place of set-
up. The charger and the battery must be set up/placed such that air circulation is
possible. Never cover the charger and the battery.
Never insert objects into any openings that may be present in the housing; lethal
hazard due to electric shock!
Condensation may form when the product is brought from a cold room into a
warm one. Wait until the product has reached room temperature before connect-
ing it to the mains voltage and switching it on. This may potentially take several
hours. Otherwise, this may not only destroy the product, but there is also the risk
of a life-threatening electric shock!
This product should never be touched with wet hands. Otherwise, there is the risk
of a fatal electric shock!
The charger and the charging cable must not be pinched or damaged by contact
with sharp edges.
Do not use the product if it is damaged. There is a risk of a life-threatening electric
shock!
Safe operation can no longer be assumed if:
- the product shows visible signs of damage
- the product does not work at all or works poorly (leaking smoke or a smell of
burning, audible cracking noises, discolouration to the product or the adjacent
surfaces)
- the product was stored under unfavourable conditions
- it was exposed to heavy loads during transport
If the product is damaged, do not touch it; there is a danger to life from electric
shock! First, turn off the mains voltage to all poles of the mains socket to which
the product is connected (switch off at the corresponding circuit breaker or
remove the safety fuse, then turn off at the ELCB). Only then should you unplug
the charger from the mains socket. Discontinue use of the product, take it to a
specialised workshop or dispose of in an environmentally friendly manner.
Use the product only in temperate climate, never in a tropical climate.
Do not leave packaging material carelessly lying around. It may become a dan-
gerous plaything for children.
Also observe the safety and operating instructions of the rechargeable battery that
is connected to the product.
When charging rechargeable batteries, always observe the charging instructions
provided by the manufacturer of the batteries concerned.
In the case of improper handling (wrong battery type; wrong voltage range or
reversed polarity and simultaneous failure of the safety features of the charger),
the rechargeable battery can be overcharged or destroyed. In the worst case, the
rechargeable battery can explode and thereby cause serious damage.
Keep transmitters (mobile phones, transmitters for models, etc.) away from the
charger because the resulting radio transmission can disturb the charging process
or damage the charger and thereby also the rechargeable battery.
Do not leave the charger, and the rechargeable batteries that are connected to it,
unattended while in operation.
b) Other information
If you have doubts about how the product should be operated, or about safety or
the connection of the product, consult an expert.
Maintenance, adjustment and repair work may be carried out only by an expert or
a specialist workshop.
If in doubt about how to connect the device correctly, or should any questions
arise that are not answered in these operating instructions, please contact our
technical service or another specialist.
G
OPERATING INSTRUCTIONS
BC-1001 AUTOMATIC CHARGER
ITEM NO. 1406342
INTENDED USE
The product is intended to charge lead rechargeable batteries of the types lead-gel, lead-acid
or lead-eece with a nominal voltage of 6 V or 12 V and a capacity from min. 1.2 Ah up to
max. 14 Ah with an automatic charger. The battery is connected via a charging cable with
alligator clips.
Only use the charger on standard household AC voltages 220 - 240 V/AC and in indoor loca-
tions. The charger is protected against incorrect polarity and short-circuit.
For safety and approval reasons (CE), you may not convert and/or alter the product. Non-
rechargeable batteries (e.g., zinc-carbon, alkaline, etc.) or other rechargeable battery types
(e.g., NiMH, Li-ion, etc.) are not to be connected and recharged.
If you use the product for purposes other than those described above, the product may be
damaged. Furthermore, improper use may cause risks such as short-circuits, re, explosion,
electric shocks, etc. Please read the operating instructions carefully and do not discard them.
If you pass the product on to a third party, please hand over these operating instructions as
well.
This product complies with the applicable National and European requirements. All names of
companies and products are the trademarks of the respective owners. All rights reserved.
PACKAGE CONTENTS
• Charger
Operating instructions
Up-to-date Operating Instructions:
1. Open www.conrad.com/downloads in a browser or scan the
displayed QR code.
2. Select document type and language and enter the item
number into the search eld. After submitting the query you
can download displayed records.
SAFETY INSTRUCTIONS
Please read the operating instructions carefully and pay particular attention
to the safety instructions. We do not assume liability for injuries/material
damages resulting from failure to observe the safety instructions and the
information in these operating instructions regarding the proper handling of
the product. Furthermore, in such cases, the warranty/guarantee will be null
and void.
a) Persons / product
The product is not a toy. Devices operated on mains voltage should not be used
by children. Therefore, be especially careful when children are around.
Children may try to poke objects into any available openings in the charger. Not
only does this damage the product, but it also poses an injury hazard as well as a
risk of fatal electric shock!
The product is constructed according to Protection Class II. Only a standard
safety mains socket connected to the public supply grid may be used as the volt-
age source.
The outlet used for the connection must be located in direct proximity to the
charger and easily accessible.
The product must not become damp or wet; it is only intended for use in dry,
indoor locations.
Never pour any liquids above or next to the product. Do not place any containers
with liquids, e.g., vases or plants, on or next to the charger. Liquids may seep
into the casing and thus impair the electrical safety of the device. Furthermore,
there is a signicant risk of re or of a lethal electric shock! If any liquid has still
managed to enter the device, immediately turn off the power supply to the mains
socket at which the product is connected (turn off the fuse / circuit breaker /
residual current operated circuit breaker of the associated circuits). Only then can
you unplug the product from the mains socket and contact a specialist. Do not use
the product any longer.
VERSION 01/16