User manual

42
11. PARAMETER DISPLAY
a) Symbols for Active Mode and Charge Condition
Thefollowingsymbolsprovideaquickoverviewofthechargeconditionoftherechargeablebatteryandthecurrent
mode:
The rechargeable battery is being charged
The rechargeable battery is being discharged
 Coolingpauseafterchargingduringrechargeablebatteryprogramme„MAXIMIZE“
Error
Charge condition full
 Chargeconditionat
The symbols for the charge condition serve only to estimate how far the charge or discharge process has
progressed.Whenchargingthebatteryiconllsfromthebottomtothetopwhileitemptiesfromtopdownwhen
discharging. Conclusions regarding the expected time remaining until the end of the programme are not possible
from this.
b) Rechargeable Battery Voltage
The voltage of the battery is indicated in the unloaded condition (and can therefore not be measured during opera-
tion).
c) Charge/Discharge Current
Duringcharginganddischarging,thedeviceshowsthecurrent„I“owingthroughtherechargeablebattery.Ifno
currentisowing(e.g.inthemode„READY“or„ERROR“),thedisplayshows„I=0.000A“.
d) Time Measurement
Thedisplayshowsthetimeindays/hoursandminutes(„DD/HH:MM“)overwhichthebatterywaspaused,charged
anddischarged.Thetimerequiredformaintenancechargingisnotconsidered.
e) Fed in and Removed Capacity
The capacity (C) charged into the battery, as well as the discharged capacity (D) is stated in milliampere hours
(mAh). In programmes with several charge and discharge cycles, only the current values are displayed. Data of the
previouscyclearedeleted.Nocalculation,displayoradditionofthecapacityofamaintenancecharge(„TRICKLE“)
are performed.