User manual

No display in the device display and/or no reaction due to EMC impulses, electrostatic discharge = ESD,

surge impulses or line-conveyed interference resistance

• Disconnectthechargerfromthemainsforseveralminutesandreconnectit.

Signicant warming on the casing

• Thehighperformanceofthedeviceresultsinheatingofthetopandbottomofthecasing;thisisnofault.Ensure

good ventilation of the charger.

SD/SDHC memory card cannot be initialised

• Display„WRITEERR“:Wrongformat.OnlySDandSDHCmemorycardswithupto32GBandFAT/FAT32format-

tingaresupported.SDXCcardsarenotsupported.

• Display„TOOSLOW“:Thememorycardisnotcompatibleanddoesnotcomplywiththerequiredtimings.This

can happen when using older and particularly slow memory cards.

• Display„PROTECTED“:Thememorycardiswriting-protected.Checkthesliderontheleftsideofthememory

card.