User manual
45
USE ONLY WITH A XXXX XXXX
Remote
Sensing
10
9
11
9 Remote control connection Remote Control
10 Connector sockets Remote Sensing
11 Cold device connection and mains fuse
7. OPERATION
The laboratory network device is not a charger. Use a suitable charger with
corresponding charging shutdown to charge batteries. The housing surface
heats up during longer operation with nominal load. Caution! Possible
danger of burning. Therefore please ensure adequate ventilation of the
power supply and never operate it partially or wholly covered, to avoid
possible damage.
When connecting a consumer please ensure that it is switched off.
A switched on consumer can cause sparks when connecting it to the
output sockets of the power supply which can damage the sockets or the
connected lines and/or terminals of these.
If you do not need your power supply , switch it off and disconnect it
from the network. The displays stay on for a few seconds after switch off
to discharge the internal condensators and save the parameters last set.
Please ensure a sufcient conductor cross section of the DC connection
lines since an overload can lead to cable re.
a) Connecting the power cable
1. Connect the protective contact power cable provided to the cold device connection (11) at
thepowersupply.Pleaseensureasecuret.