User manual

48
It could be that the voltage setting requires approx. 1-2 seconds to adjust
from a high to a low voltage value through the large control range.
The device works in constant voltage mode during normal operation. This means
that the power supply delivers a constant preset output voltage. This mode is
signaled with the green C.V. status display (2).
c) Connecting a consumer
When connecting a consumer to the power supply please ensure that it is
switched off. The maximum power consumption of the connected consumer
should not exceed the specications in the technical data.
Dangerous contact voltages (> 75 VDC) can be generated with the series
connection of outputs of several power supplies, which could be a risk
to life when touching. Only insulated accessories (connection cables,
measuring lines etc.) may be used from this voltage . The use of metallic
cables and contacts should be avoided. All these blank points should be
covered with suitable, ame resistant insulating material or other measures
and protected from direct contact and short circuits.
Please ensure a sufcient conductor cross section for the intended current
strength .
1. Remove the connected consumer from the output.
2. Switch on the power supply via On / off switch POWER (1) The display (2) lights up and the
voltage and current indicator appears in the display.
3. Set the parameters according to your guidelines as described in the chapter "Start up".
Check the correctly set output voltage once more.
4. Connect the positive pole (+) of the consumer to the red socket "+" and the negative pole (-)
to the black socket "-" of the output.
The load can be connected via the green sockets where required.