User manual

50
10. "PRESET" MEMORY LOCATION OPERATION
Three xed voltages including the current settings can be directly selected via the preset
function in the device. All three memory locations (PRESET 1, 2, 3) are preset by the factory.
Type
Memory
PRESET 1 PRESET 2 PRESET 3
Voltage Current Voltage Current Voltage Current
CPPS-160-42 5 V Maximum 13.8 V Maximum 20 V Maximum
CPPS-160-84 5 V Maximum 13.8 V Maximum 20 V Maximum
Please ensure that no consumers are connected.
The data memory can be set via the software provided. Please also note the
chapter "Control with PC software".
1. Press any selection button PRESET 1, 2, 3 (8). The button lights up and the preset values
are indicated in the display (2).
2. You can change the preset voltage and current values according to your needs. The output
voltage can be changed at the VOLTAGE setting controller (4) and the output current at the
CURRENT (5) setting controller.
If you change the preset voltage and current values, these values are stored,
if the laboratory power supply is switched off. Always test the values set
before connecting a consumer.
3. Press the SHIFT (8) button and then any selection button PRESET 1, 2, 3 (8). To test the
preset values. The preset values are indicated in the display (2). The display switches back
to normal display after approximately 2 seconds.
Read the chapter "Resetting the values set" to reset the values set to the factory
settings.