User manual

The voltage at the remote control connection should not exceed 5 V. The

connections should not be short circuited.

c) Control via controllable resistance (potentiometer)

The power supply can be remote controlled with an external potentiometer (5 kOhm) over the

entire range for voltage and current.

Connect the connection lines to the remote sockets as illustrated.

Voltage setting "V"

• Connection 1 at one end of the resistor.

• Connection 2 at the middle sliding contact

of the resistor.

• Connection 4 at the second end of the

resistor.

Current setting "I":

• Connection 1 at the end of the resistor.

• Connection 3 at the middle sliding contact

of the resistor.

• Connection 4 at the second end of the

resistor.

The connections 1 and 4 should not be short circuited.

d) Output remote control (on/off)

The DC output can be switched on and off via a switch contact. Proceed as follows for the

connection:

1. Connect the connection lines to the remote sockets as illustrated.

2. Connect the 4 and 5 connection to a potential free switch contact.

3. The statusdisplaysC.V.andC.C.ashwhenthe outputis switchedoff.Inaddition the

display (2) indicates the current settings of the output voltage and output current.

4. You can determine the output values with the setting controller for voltage VOLTAGE (4) and

current limitation CURRENT (5) when the output is switched off.