User manual

15. SENSE FUNCTION

The sense function is an automatic voltage control for the connection sockets MAIN OUTPUT (6).

In addition two separate measurement lines are connected parallel to the connection lines. The

voltage drop, which occurs at the connection lines, is measured on both these measurement

lines. This voltage drop automatically balances the laboratory power supply so that the voltage

actuallysettstheconsumer.

1. Switch off the power supply and consumer.

2. Alwaysrstconnectthepowersupplylinesofthepowersupplytotheconsumer.Please

note the correct polarity.

3. Press the terminal release inside with a small screw driver on the rear connection sockets

Remote Sensing (10) and stick the cables into the clamp openings. Check the secure

position.

4. Now connect both sense lines to the consumer at the correct polarity. The conductor cross

section for the sense lines must always amount to at least 0.34 mm

5. Alwaysloosentheconnectionsinreverseorder(rstthesenselinesandthenthe

connection lines).

Remote

Sensing

Please ensure that the sense cables are connected as near as possible to

the connection point of the consumer. Please note the correct polarity.

Never short circuit the sense lines.