Instructions
Table Of Contents
- Copyright Declaration
- Contents
- Chapter 1 Introduction
- Chapter 2 Function Introduction
- Chapter 3 Waveform Generator
- Chapter 4 Troubleshooting
- Chapter 5 General Care and Cleaning
- Appendix A: Technical Specifications
- Appendix B: Accessories
- Appendix C Harmful and Poisonous Substances or Elements
- Appendix D To replace the fuse
- Appendix E Open Source Information
Digital Storage Oscilloscope 3
1.2 Prepare Instrument for Use
Adjust the Supporting Legs
Adjust the supporting legs properly to use them as stands to tilt the oscilloscope
upwards for stable placement of the oscilloscope as well as better operation and
observation.
Connect the Power Cord
Connect the power cord as desired.
This oscilloscope can accept 100-240 V, 45-440 Hz AC power supply. Please use the power
cord supplied with the accessories to connect the oscilloscope to the power source as shown
in the figure below.
Turn the instrument on by pressing the power switch in the lower left corner of front
panel. If the instrument does not turn on, verify that the power cord is firmly connected.
Also make sure that the instrument is connected to an energized power source.
Power Switch:
To turn off the instrument, please press power switch.