Instructions

Digital Storage Oscilloscope 42
4. Press the Buad Tate softkey, and turn the Universal Knob to set the Baud Rate.
5. Press the Idle Level softkey, and turn the Universal Knob to set the Idle Level.
6. Press the Identifier softkey, and turn the Universal Knob to set the Identifier.
Note: The Identifier means Remote ID and Data ID.
7. Press When softkey to set trigger condition.
• Start - The oscilloscope triggers at the start of a frame.
• Remote ID- The oscilloscope triggers on remote frames with the specified ID.
• Data ID - The oscilloscope will trigger on data frames matching the specified ID
• Frame ID - The oscilloscope will trigger on data frames od remote frames
matching the specified frame data.
• Data Frame and data –The oscilloscope will trigger on data frames matching the
specified data frame ID and data.
a. Press the Data softkey to select the ID number.
b. Press the Data softkey to move the current bit, and turn the universal to select
the byte to be set.
--Press Data software, use V0 to set the data, refer to
2.7.10;
--Data Mask: When set to "ON", the data is ignored when it is triggered; the
setting is "OFF", and the data on the data line must be consistent with the data
of the index so that it can trigger;
--Data Index: The range is 0 to 3. It can set four hexadecimal data.
• Error –The oscilloscope will trigger on error frames matching the specified data.
• All Error - The oscilloscope will trigger when any form error or active error is
encountered. Not include judgment of CRC errors.
• Ack Error –The oscilloscope will trigger when the comfirm is high.
• Overload Frame - The oscilloscope will trigger on overload frames.
For example1, Source: CH1; Baund Rate: 1000000; Idle Level: Low; When: Start Bit.
The trigger result is shown below: