Instructions
Table Of Contents
- Copyright Declaration
- Contents
- Chapter 1 Introduction
- Chapter 2 Function Introduction
- Chapter 3 Waveform Generator
- Chapter 4 Troubleshooting
- Chapter 5 General Care and Cleaning
- Appendix A: Technical Specifications
- Appendix B: Accessories
- Appendix C Harmful and Poisonous Substances or Elements
- Appendix D To replace the fuse
- Appendix E Open Source Information
Digital Storage Oscilloscope 65
directions on the screen.
2.12.3
Pass/Fail
“Pass/Fail” is used for judging whether the input signal is in a built rule range and
outputting the past or failed waveform so as to detect the change condition of the
signal.
Page 1 of the pass/fail function menu:
Option
Setup
Description
Pass/Fail
ON
OFF
Run the pass/fail function.
Stop the pass/fail function.
Source CH1~CH4 Select the signal input channel.
Regular
Skip to a rule setup menu.
Message
OFF
ON
Close waveform pass/fail time display information.
Open waveform pass/fail time display information.
Stop
On
Off
Enter STOP state if output exist.
Continue to run if output exists.
Page 1/2
Skip to page 2 to the pass/fail menu.
Page 2 of the pass/fail function menu:
Option Setup Description
Output
ON
OFF
Mode
Pass
Fail
Pass Ring
Fail Ring
Output a negative pulse train when the test is
passed.
Output a negative pulse train when the test is
failed. .
Return
Skip to Utility menu
Regule setup menu:
Option Setup Description
Vertical
Use the Universal knob to set a horizontal
tolerance range: 0.020div-4.00div
。
Horizontal Use the
Universal knob
to set a vertical