Instructions
Table Of Contents
- Copyright Declaration
- Contents
- Chapter 1 Introduction
- Chapter 2 Function Introduction
- Chapter 3 Waveform Generator
- Chapter 4 Troubleshooting
- Chapter 5 General Care and Cleaning
- Appendix A: Technical Specifications
- Appendix B: Accessories
- Appendix C Harmful and Poisonous Substances or Elements
- Appendix D To replace the fuse
- Appendix E Open Source Information
Digital Storage Oscilloscope 68
Single-Period
Set the horizontal scale to display about one period of the
waveform.
Autoscale
Autoscale setting.
Source
Select the source: only display the current source or all
sources.
Cancel
Let the oscilloscope recall the previous setup.
2.13.2 Default Setup
When you push the DEFAULT SETUP button, the oscilloscope will display the CH1
waveform and remove all the others. When you are at the default setup, press F1 to
Undo Preset. Then the oscilloscope returns to the status before default setup. The
table below gives the options, buttons and controls that change settings at default
setup.
Menu or System Option, Button or Knob Default Setting
Acquire
(Three mode options)
Normal
Averages 16
Run/Stop Run
Cursor
Type
Off
Source CH1
Horizontal (amplitude) ±3.2div
Vertical (time) ±4div
Display
Type
Vectors
Persist Off
Format YT
Horizontal
Window Mode
Single-window
Trigger Knob Level
Position 0.00s
SEC/DIV 200μs
Math
Operation
—
Source
CH1-CH2
Position
0div
FFT
Vertical Scale 20dB
FFT Operation