Instructions
Table Of Contents
- Copyright Declaration
- Contents
- Chapter 1 Introduction
- Chapter 2 Function Introduction
- Chapter 3 Waveform Generator
- Chapter 4 Troubleshooting
- Chapter 5 General Care and Cleaning
- Appendix A: Technical Specifications
- Appendix B: Accessories
- Appendix C Harmful and Poisonous Substances or Elements
- Appendix D To replace the fuse
- Appendix E Open Source Information
Digital Storage Oscilloscope 72
3.1 Set Wave Type and Parameters
1. Press the [Wave Gen] button on the front panel to open the arbitrary waveform
generator function.
2. Press the Wave softkey; then turn the Universal Knob to select the desired
waveform and push down the knob to confirm. Press the Wave Type softkey
continually can also select the waveform type.
3. Press the Frequency softkey to set frequency.
4. Press the Amplitude softkey to set amplitude.
5. Press the Offset softkey to set offset.
6. Press the Duty softkey in the second page to set the duty of Square and Ramp
waveform.
Set the value of frequency, Amplitude or Offset:
: Horizontal arrow, turn the Universal Knob to select a digit.
: Vertical arrow, turn the Universal Knob to set the value of the selected digit.
The waveform will output from GEN OUT BNC port.
7. Press the modulation softkey to enter modulation menu.
The modulation types are AM and FM.
8. Press the Burst softkey to enter burst menu.
The burst types are N cycle and Gate.