Instructions
Table Of Contents
- Copyright Declaration
- Contents
- Chapter 1 Introduction
- Chapter 2 Function Introduction
- Chapter 3 Waveform Generator
- Chapter 4 Troubleshooting
- Chapter 5 General Care and Cleaning
- Appendix A: Technical Specifications
- Appendix B: Accessories
- Appendix C Harmful and Poisonous Substances or Elements
- Appendix D To replace the fuse
- Appendix E Open Source Information
Digital Storage Oscilloscope 78
Chapter 5 General Care and Cleaning
5.1 General Care
Do not put or leave the device in a place where the LCD display will be exposed to
direct sunlight for long periods of time.
Note: To avoid damage to the oscilloscope or probes, do not expose them to sprays,
liquids, or solvents.
5.2 Cleaning
Examine the oscilloscope and probes as often as operating conditions require. To
clean the exterior surface, perform the following steps:
1） Use a lint-free cloth to remove floating dust on the outside of the oscilloscope and
probes. Take care to avoid scratching the glabrous display filter.
2） Use a soft cloth dampened with water to clean the oscilloscope. For more efficient
cleaning, you may use an aqueous solution of 75% isopropyl alcohol.
Note: To avoid damage to the surface of the oscilloscope or probes, do not use any
corrosive or chemical cleaning agents.