Manual

35
d) Setting up the meter/mounting to a tripod
The meter can be secured to a tripod (included with the product) via the tripod socket (10) on the rear of the device.
Thisenablessoundlevelmeasurementstobetakenwithoutbeinginuencedbynoisefromtheuser.
e) Switching on and off
• Brieypresstheon/offbutton (1) to switch on the meter. All display elements will appear. After a short initialisa-
tion phase (display and system test), the measuring device will be ready to use.
• Press the on/off button (1) to turn the meter off. The display will turn off and the meter will switch off.
• The meter will save the last setting and display it when the meter restarts.
9. Setting variable
a) Available settings in the overview
Change and save the setting options for the respective measurement to the memory.
Setting Menu icon Setting variable
Temperature unit TEMP °C or °F
Light intensity unit LIGHT LUX or FC
Sound level unit SOUND dBA or dBC
Offset Type KJ Temperature offset
Wind speed unit VEL Knots m/s Mph, ft/min km/h
Unitoftheairowrate FLOW ft3/min, m3/min
Unit of area AREA in
2
c, cm
2
, ft
2
Size of the area AREA The cross-section used as the measuring surface
Automatic power-off SLP On or off
b) Changing the unit settings
• Press and hold the button (2) for approximately 2 seconds to access settings mode. "SETUP" will appear on
the LCD display (7) to indicate that settings mode is enabled. The "Unit" symbol will appear on the LCD display.
• Press the (13) or (14) button to select the measurement mode for the unit that you want to change.
• Press the button(15)toconrmyourselection.Thecurrentunitwillbedisplayed.
• Press the (13) or (14) button to change the unit to one of the available options.
• Press the button(15)toconrmandsavethenewsetting.
• Whenyouhavenishedchangingthesettings,pressandholdthe button (2) for approximately 2 seconds to
exit settings mode.