Technical data

33
Assembly
19. Install the sea-water pump and the cooling water
pipes.
20. Install the injectors and the return fuel pipe. Tight-
ening torque for the injectors 20 Nm (14.7 ft.lbs.). Also
install the exhaust elbow and the water pipe between
the thermostat housing and the exhaust elbow.
21.
Fit the valve cover using a new gasket. Make sure
that the round hole for the crankcase ventilation is in
the right position. Fit the decompression device lever.
Fit the pressure pipes between the injectors and the
injection pumps. Also refit the inlet air silencer.
22. Install the starter motor, the alternator and the
alternator V-belt. Also install the electrical distribution
box and hook-up the cable harness.
23.
Fill up with lubricating oil to the correct level. Re-
garding quantity and quality, see under “Technical
Data”.
24.
Venting the fuel system
A. Open the venting screw on the fuel filter approx. 4
turns. Watch out for fuel-splashes.
B. Use the hand-pump to pump fuel until fuel free from
air bubbles is coming out. Close the venting screw.
C. Ease off the fuel pressure pipe nuts at the injec-
tors. Position the throttle control in the position for full
speed and turn the engine with the starter motor until
fuel comes out of the fuel pressure pipes. Tighten the
fuel pressure pipe nuts.