Operation Manual

||
01 Volvo On Call (VOC)
01
10
* Option/accessory, for more information, see Introduction.
it is possible to use the mobile app to set the
time when charging is to take place.
Reminder to plug in the charging cable
6
You can enable reminders in your mobile app
if you forget to plug in the charging cable
when the car has been parked.
Preconditioning
6
Preconditioning prepares the car's drive sys-
tems and the passenger compartment before
departure so that both wear and energy
needs during the journey are reduced. The
mobile app is used in the same way as for
remote heater start.
Related information
•
Available Volvo On Call* functions (p. 7)
•
Comfort services with Volvo On Call*
(p. 8)
•
PIN code for Volvo On Call* (p. 18)
Remote heater start* via SMS
Cars equipped with fuel-driven engine block
heater and passenger compartment heater in
combination with VOC* offer the same setting
options for the heater as inside the car using a
normal mobile phone. It is possible to config-
ure the timer settings by sending the desired
setting using a mobile phone, see remote
heater start (p. 10).
Being able to control the heater in the car
with your mobile phone means effortless
operation of the heater, increasing the com-
fort experience at a cost of an SMS.
The heater function has two times, in the
description called T1 and T2. These show
when the car has reached the set tempera-
ture. In order that only the authorised user is
able to control the heater, the SMS message
must contain the car's registration number
7
followed by the VOC system's PIN code.
Related information
•
Remote heater start* via SMS (p. 10)
•
Volvo On Call* mobile app (p. 8)
•
PIN code for Volvo On Call* (p. 18)
Remote heater start* via SMS
The heater in the car is controlled via SMS.
NOTE
Take care with where the car is parked
when using the remote start function for
the heater as the heater emits exhaust
fumes, see the owner's manual for the car
for more information.
NOTE
Each subcommand is followed by a #
character. The message should be written
as a string without spaces and finished
with a # character, e.g. # PIN code # 1 #
Phone number
The message must be sent to the following
number: [phone]. For some mobile
phones, it is possible to create a message
template in order to facilitate simpler and
faster operation.
Direct commands
To start the heater directly:
1. Enter the car's registration number fol-
lowed by # PIN code # 1 #
2. Send the message.
6
Only applies to the V60 PLUG-IN HYBRID.
7
The registration number can contain both uppercase and lowercase letters.