Owner’s Manual

INSTRUMENTS AND CONTROLS
}}
105
1. Position the end of your hand-held transmit-
ter 1–3 inches (5–14 cm) away from the
HomeLink button you wish to program while
keeping the indicator light in view.
2. Simultaneously press and hold both the
chosen HomeLink and hand-held transmitter
buttons until the HomeLink indicator light
changes from a slow to a rapidly blinking
light. Now you may release both the Home-
Link and hand-held transmitter buttons.
NOTE
Some devices may require you to replace this
Programming Step 2 with procedures noted
in the “Gate Operator / Canadian Program-
ming” section. If the HomeLink indicator light
does not change to a rapidly blinking light
after performing these steps, contact Home-
Link at www.homelink.com/
www.youtube.com/HomeLinkGentex or by
phoning the hotline at 1–800–355–3515.
3.
Firmly press, hold for five seconds and
release the programmed HomeLink button
up to two separate times to activate the door.
If the door does not activate, press and hold
the just-trained HomeLink button and
observe the indicator light.
•
If the indicator light stays on constantly,
programming is complete and your
device should activate when the Home-
Link button is pressed and released.
•
If the indicator light blinks rapidly for two
seconds and then turns to a constant
light continue with “Programming”
steps 4-6 to complete the programming
of a rolling code equipped device (most
commonly a garage door opener).
4. At the garage door opener receiver (motor-
head unit) in the garage, locate the “learn” or
“smart” button. This can usually be found
where the hanging antenna wire is attached
to the motor-head unit.
5. Firmly press and release the “learn” or
“smart” button. (The name and color of the
button may vary by manufacturer.) There are
30 seconds to initiate step 6.
6. Return to the vehicle and firmly press, hold
for two seconds and release the pro-
grammed HomeLink button. Repeat the
“press/hold/release” sequence a second
time, and, depending on the brand of the
garage door opener (or other rolling code
equipped device), repeat this sequence a
third time to complete the programming
process.
HomeLink should now activate your rolling code
equipped device.