Owner’s Manual

||
MAINTENANCE AND SERVICING
338
2. Reinstall the headlight housing and locking
pins. The short locking pin should be closest
to the grille. Check that they are correctly
inserted.
The headlight housing must be properly in
place and the wiring connector correctly
reconnected before the lighting is switched
on or the remote key is inserted into the igni-
tion slot.
3. Check that the lights function properly.
Related information
•
Bulbs – introduction (p. 336)
•
Bulbs – cover (p. 338)
•
Bulbs – specifications (p. 343)
Bulbs – cover
The larger cover has to be removed in order to
change the high/low beam headlight bulbs.
Removing the cover to access the
bulbs
NOTE
Before starting to replace a bulb, see Bulbs –
introduction (p. 336).
1. Loosen the cover's four retaining screws
(3-4 turns) with a Torx T20 tool (1). The
screws should not be removed completely.
2. Push the cover to the side.
3. Remove the cover.
Reinstall the cover in the reverse order.
Related information
•
Bulbs – headlight housing (p. 337)
•
Bulbs – low beam, Halogen (p. 339)
•
Bulbs – high beam, Halogen (p. 339)
•
Bulbs – extra high beam (p. 340)