Owner’s Manual

||
MAINTENANCE AND SERVICING
344
Lighting function Wat-
tage
Bulb
Backup light 21 H21W LL
Brake light 21 P21W LL
Trunk lighting 10 SV8.5 (length
38mm)
Front footwell
lighting
3 W2, 1x9.5d
type T10
NOTE
Please consult a Volvo retailer’s Parts depart-
ment for the most up-to-date bulb specifica-
tions.
Related information
•
Bulbs – introduction (p. 336)
Wiper blades – service position
The windshield wiper blades must be in the verti-
cal (service) position for replacement, washing
or to lift them away from the windshield when
e.g., removing ice or snow.
Wiper blades in service position
CAUTION
Be sure the wiper blades are not frozen in
position before attempting to move them to
the service position.
To put the windshiield wipers in the service posi-
tion:
1.
Insert the remote key into the ignition slot
3
and press the START/STOP ENGINE but-
ton briefly to put the ignition in mode I (see
Ignition modes (p. 74) for detailed informa-
tion about the ignition modes).
2.
Press the START/STOP ENGINE button
again briefly to switch the ignition off.
3. Within 3 seconds, move the right steering
wheel lever up and hold it for at least 1 sec-
ond.
> The wipers will then move to the vertical
(service) position on the windshield.
The wipers can be returned to the normal posi-
tion by pressing the START/STOP ENGINE but-
ton briefly to put the ignition in mode I (or by
starting the engine).
CAUTION
If the wiper arms have been folded out from
the windshield while in the service position,
fold them back against the windshield before
returning the wipers to the normal position to
help avoid scratching the paint on the hood.
Related information
•
Engine compartment – washer fluid (p. 346)
3
Not necessary on vehicles with the optional keyless drive.