Owner’s Manual

INSTRUMENTS AND CONTROLS
96
Power windows
All power windows can be operated using the
control panel in the driver's door. The control
panels in the other doors only operate the win-
dow in the respective doors.
Driver's door control panel
Switch for disengaging rear door power win-
dow buttons
Rear door window controls
Front door window controls.
WARNING
•
Always remove the ignition key when the
vehicle is unattended to put the ignition in
mode 0 (see Ignition modes (p. 74) for
information about the ignition modes).
•
Never leave children unattended in the
vehicle.
•
Make sure that the windows are com-
pletely unobstructed before they are
operated.
Operating
Operating the power windows
Manual up/down
Auto up/down.
For the power windows to function, the ignition
must be in at least mode I. When the vehicle has
been running, the power windows can be oper-
ated for several minutes after the remote key has
been removed from the ignition slot, or until a
door has been opened.
NOTE
•
Movement of the windows will stop if they
are obstructed in any way.
•
To reduce buffeting wind noise if the rear
windows are opened, also open the front
windows slightly.
Manual up/down
–
Move one of the controls up/down slightly.
> The power windows move up/down as
long as the control is held in position.
Auto up/down
–
Move one of the controls up/down as far as
possible and release it.
> The window will open or close completely.
Resetting
If the battery has been disconnected, the auto
open function must be reset so that it will work
properly.
1. Gently raise the front section of the button to
close the window and hold it for one second.
2. Release the button briefly.
3. Raise the front section of the button again
for one second.