Installation & Assembly

ManualsBrandsVONN Lighting ManualsCeiling LightsRUBIK 7.25" 5-Light LED Adjustable Recessed Downlight W/Trim 100-277V New Construction IC Rated Beam Angle 34 Degree White

INSTALLATION GUIDE:

RUBIK SERIES

VONN LIGHTING MODEL# VMDL000605C012

LED INFO & WARNINGS

Please read and understand the entire manual

before attempting to assemble, operate, or install

the product.

VONN highly recommends to use a qualiﬁed,

licensed electrician to install the ﬁxture.

All parts must be used as indicated in these

instructions. Do not substitute any parts, leave

parts out, or use any parts that are worn or broken.

Inspect the LED ﬁxture prior to installation to make

sure that it has not been damaged during shipping.

Please handle the LED light with care when

unpacking. Do not apply pressure to the LED’s, do

not open any factory sealed compartments, and do

not touch the LEDs with your hands.

Shut “OFF” the electricity at main fuse box.

Do not remove or replace VONN manufactured

parts that is provided with the ﬁxture.

Place the wall switch in the “OFF” position of the

room you are installing the ﬁxture.

Make sure that you have all necessary parts by

checking the parts list. If any part is missing or

damaged please contact VONN LIGHITNG

CUSTOMER SERVICE at 888-604-8666 for

a replacement.

VONN recommends to install the ﬁxture on

its own independent circuit. Dd not install the

ﬁxture on the same circuit with the other

appliances, or HVAC systems.

TOOLS YOU MAY NEED

GOGGLES

TAPE MEASURE

RUBBER

GLOVES

PHILLIPS

LADDER

DRILL

SCREW DRIVER

www.vonn.com

PARTS LIST

Wire

Connectors x 5

CIRCUIT BOX

OFF

VONN LIGHTING MODEL#

Summary of content (8 pages)

PAGE 1
INSTALLATION GUIDE: RUBIK SERIES VONN LIGHTING MODEL# VMDL000605C012 TOOLS YOU MAY NEED GOGGLES RUBBER GLOVES PHILLIPS SCREW DRIVER DRILL CIRCUIT BOX PARTS LIST A TAPE MEASURE OFF A. Wire Connectors x 5 ON OFF LED INFO INFO & & WARNINGS WARNINGS LED LED INFO & WARNINGS Please read and understand the entire manual before attempting to assemble, operate, or install the product. Make sure that you have all necessary parts by checking the parts list.
PAGE 2
Wiring Diagram Electric Box Earth/Ground Input: black and white wire connect AC 100-277V Input Fixture Ouput + L UL Listed 0-10V Dimmer Driver N Red Black + - UL Listed LED lighting RD GND UL Listed Terminal Block Gray Purple dim - SPECIFICATIONS www.vonn.
PAGE 3
Instructions Fig. 1 Fig. 2 RECTANGLE: CUT OUT L7” x W2 1/4” (L178mm x W58mm) 1. Cut (7” x 2 1/4“) hole in the ceiling (Ceiling thickness 1/2” to 1 1/2”) Fig. 3 Green / Ground Black / Hot White / Neutral Dim-gray(0-10V) 2. Pull building supply wires through ceilling cutout and open fixture box door. Remove desired housing knockout and feed building wires into housing using appropriate connector. Fig. 4 Dim+purple(0-10V) Cable to fixture Power supply 3.
PAGE 4
Instructions Circuit Box ON www.vonn.
PAGE 5
GUIDE D’INSTALLATION : SÉRIE RUBIK MODÈLE D’ÉCLAIRAGE VONN Nº VMDL000605C012 OUTILS DONT VOUS POURRIEZ AVOIR BESOIN LUNETTES DE PROTECTION LISTE DES PIÈCES MÈTRE RUBAN GANTS EN C AOUTCHOUC TOURNEVIS CRUCIFORME ÉCHELLE PANNEAU ÉLECTRIQUE ARRÊT (OFF) A. Connecteurs de fils x 5 A PERCEUSE MARCHE (ON) ARRÊT (OFF) INFORMATIONS ET MISE EN GARDE CONCERNANT LES DEL Veuillez lire et comprendre l’ensemble du manuel avant de procéder à l’assemblage, d’utiliser ou d’installer le produit.
PAGE 6
Schéma de câblage Boîte électrique Mise à la terre Entrée : fil noir et blanc connecté au courant alternatif 100-277 V Entrée Luminaire Sortie + L Pilote de variation 0-10 V N homologué UL Red Black + - Éclairage à DEL homologué UL RD Bornier homologué UL GND Gray Purple dim - dim+ Commande de variateur 0-10 V homologuée UL SPÉCIFICATIONS Entrée : 100-277V Installation : I C pour tous les modèles Variation : 0-10V www.vonn.
PAGE 7
Instructions Fig. 1 Fig. 2 DÉCOUPE RECTANGULAIRE L7 po x l2 1/4 po (L178 mm x l58 mm) 1. Découpez une ouverture (7 po x 2 1/4 po) dans le plafond (épaisseur du plafond de 1/2 à 1 1/2 po) Fig. 3 Vert / Mise à la terre Noir / Chaud Blanc / Neutre Dim-gris(0-10 V) 2. Tirez les câbles d’alimentation de l’édifice par l’ouverture du plafond et ouvrez la porte du boîtier du luminaire.
PAGE 8
Instructions Panneau électrique ON MARCHE (ON) ARRÊT (OFF) www.vonn.