Specifications

QUADRAPADDLE SIGNAL CONTACTS AND MODULES USER’S MANUAL: SECTION 6 VIRGINIA PANEL CORPORATION
1/26/10
6-2 For more information visit vpc.com
Figure A. Recommended PCB layout.
2.44
2.29
.655
.300
.037
±0.080.94
7.62
.300
125.48
4.940
140.72
5.540
6.35
.250
TYP. 192 PLCS.
119.38
47 EQUAL SPCS. @ [2.54] .100
5.08
.200
4.700
±.003
7.62
@ [2.54] .100
3 EQUAL SPCS.
16.64
TYP.
8.13
.320
124.46
4.900
.096
.090
THRU
[4.37] .172 X 82
TYP 2 PLCS
.420
10.67
RECOMMENDED PCB LAYOUT
CONNECTOR MOUNTS OPPOSITE SIDE
BOARD THICKNESS = [1.57] .062
DIMENSION TOLERANCE = [.13] .005
UNLESS OTHERWISE SPECIFIED
PIN 1A LOCATION
PIN 1D LOCATION
PIN 48A LOCATION
PIN 48D LOCATION
[.15] .006 A B C
A
B
TOOLS REQUIRED
3
/
32
Allen Wrench
PCB ADAPTER INSTALLATION AND REMOVAL INSTRUCTIONS
1. Solder the header to PCB (IPC-A-610 standard is recommended
for PCB design). The PCB must be manufactured with the
header installation area complying with recommended PCB
layout (Figure A).
2. Fasten the shroud assembly to the PCB using two 2-56 x .25 at
head screws (Figure B on next page). Torque screws to 2 in-lbs
[0.22 Nm].
3. Using the supplied
3
/
32
Allen wrench, install the receiver module
into the receiver frame with the two 4-40 x 1¼ screws. Torque
screws to 4 in-lbs [0.45 Nm]. Note that screw will extend
approximately 0.75”-1.0” [19-25 mm] beyond the rear of the
receiver frame. Ensure that Position 1 is located at the top for
systems in which the modules are oriented vertically or to the
left for systems in which the modules are oriented horizontally.
Continued on next page...
QUADRAPADDLE SIGNAL CUSTOM RECEIVER PCB ADAPTER
INSTALLATION AND REMOVAL
PART # 510 150 152 / 510 109 315
Dimensions shown: [millimeters]
inches