Specifications

QUADRAPADDLE SIGNAL CONTACTS AND MODULES USER’S MANUAL: SECTION 6 VIRGINIA PANEL CORPORATION
1/26/10
6-4 For more information visit vpc.com
TOOLS REQUIRED
3
/
32
Allen Wrench
PCB ADAPTER INSTALLATION AND REMOVAL INSTRUCTIONS
1. Install the ITA module into the ITA frame with the two 4-40
double-ended studs. The long end of the stud should pass
through the ITA module (Figure A). Ensure that Position 1
is located at the top for systems in which the modules are
oriented vertically or to the left for systems in which the
modules are oriented horizontally.
2. Align the PCB adapter’s two threaded retaining sockets with
the 4-40 double-ended studs (Figure B). Ensure that Position 1
on the adapter corresponds with Position 1 on the module.
3. Using the
3
/
32
Allen wrench, carefully install the PCB adapter by
tightening the retaining sockets, turning each no more than
1½ to 2 full revolutions before alternating to the other socket.
Repeat this step until the PCB adapter is rmly engaged with
the ITA module, taking care not to over-tighten. Torque screws
to 4 in-lbs [0.45 Nm].
4. To remove the PCB adapter from the ITA frame and module,
use the same alternating method of 1½ to 2 turns until the PCB
assembly is fully disengaged.
QUADRAPADDLE SIGNAL ITA PCB ADAPTER INSTALLATION AND REMOVAL
PART # 510 109 339 / 510 151 123 / 510 151 125
VPC ITA FRAME
NOT SUPPLIED
VPC ITA MODULE
PART # 510151107
Figure A. Install ITA module into the ITA frame. Figure B. Install the PCB adapter.