Specifications

QUADRAPADDLE SIGNAL CONTACTS AND MODULES USER’S MANUAL: SECTION 6 VIRGINIA PANEL CORPORATION
1/26/10
6-6 For more information visit vpc.com
VPC ITA FRAME
NOT SUPPLIED
VPC ITA MODULE
PART # 510151107
Figure D. Install ITA module into the ITA frame.
Figure E. Install the PCB adapter.
PCB ADAPTER INSTALLATION AND REMOVAL INSTRUCTIONS,
CONTINUED
3. Fasten the shroud assembly to the PCB using two 2-56 x .25”
at head screws (Figure C). Torque screws to 2 in-lbs [0.22
Nm].
4. Install the ITA module into the ITA frame with the two 4-40
double-ended studs. The long end of the stud should pass
through the ITA module (Figure D). Ensure that Position 1
is located at the top for systems in which the modules are
oriented vertically or to the left for systems in which the
modules are oriented horizontally.
5. Align the PCB adapter’s two threaded retaining sockets with
the 4-40 double-ended studs (Figure E). Ensure that Position 1
on the adapter corresponds with Position 1 on the module.
6. Using the
3
/
32
Allen wrench, carefully install the PCB adapter
by tightening the retaining sockets, turning each no more
than 1½ to 2 full revolutions before alternating to the other
socket. Repeat this step until the PCB adapter is rmly
engaged with the ITA module, taking care not to over-
tighten. Torque screws to 4 in-lbs [0.45 Nm].
7. To remove the PCB adapter from the ITA frame and module,
use the same alternating method of 1½ to 2 turns until the
PCB assembly is fully disengaged.
QUADRAPADDLE SIGNAL CUSTOM ITA PCB ADAPTER INSTALLATION/REMOVAL
PART # 510 151 121 / 510 109 316
Figure C. Attach shroud.