Specifications

QUADRAPADDLE SIGNAL CONTACTS AND MODULES USER’S MANUAL: SECTION 5 VIRGINIA PANEL CORPORATION
1/26/10
5-1 For more information visit vpc.com
QUADRAPADDLE SIGNAL STANDARD/90 SERIES MODULE INSTALLATION AND REMOVAL
Figure A. Receiver Module.
POSITION 1
Figure B. ITA Module.
TOOLS REQUIRED
3
/
32
Allen Wrench
INSTALLATION INSTRUCTIONS
1. Place the module in the receiver or ITA until the upper and
lower module screws touch the mating holes in the inner
frame. Ensure that Position 1 is located at the top for systems
in which the modules are oriented vertically or to the left for
systems in which the modules are oriented horizontally.
2. Using a
3
/
32
Allen wrench, tighten the top screw 1 to 2 full
revolutions, while pushing lightly against the face of the
module.
3. Maintain this pressure while tightening the bottom screw 1 to
2 full revolutions.
4. Repeat this sequence until the module is seated. Torque the
screw to 4 in-lbs [0.45 Nm].
REMOVAL INSTRUCTIONS
1. To remove, loosen the top screw 1 to 2 full revolutions. Loosen
bottom screw 1 to 2 full revolutions.
2. Repeat this sequence until the module is separated from the
receiver or ITA.
NOTE: For optimum performance and system longevity, distribute
the contact load evenly throughout the module.