USER MANUAL HURRICANE 620 LUMEN GENERAL PURPOSE LED FLASHLIGHT FG-B25
Thank you for choosing Vulta. The Vulta Hurricane FG-B25 projects a crisp, white light with a 620-lumen maximum output. Designed as a reliable, general-purpose flashlight, the FGB25’s four constant-on modes provide a range of illumination options depending on your needs—whether it’s sending a bright beam of light down the street or a low glow for reading a map on the side of the highway. In addition to constanton, there are strobe and SOS modes for emergency situations and signal communication.
efficiency with high drive-current. The LED is housed in an ultraclear, tempered glass lens that optimizes resistance to impacts and scratches and maximizes throw distance. Crafted from MIL-SPEC Type III hard anodized aluminum alloy with a stainlesssteel bezel, and with a waterproof rating of IPX-8, the Hurricane FG-B25 is a rugged tool that will withstand harsh environments. The removable titaniumalloy clip can mount the unit for handsfree use and easy transportation.
PRECAUTIONS ⚠⚡ • Please read and follow these instructions and keep this manual in a safe place. • This flashlight is extremely bright and can cause temporary or even permanent blindness. Do not shine the flashlight in the eyes of any person or animal. When powering on the flashlight, make sure to point it down or away from you and anyone else. • The surface of this product can become hot after prolonged use. Be careful when touching it, and make sure to keep it away from anything flammable or combustible.
• Always install batteries of the same type, brand, and age. Do not combine different types or brands, or old and new batteries. • Install the batteries in the proper orientation as indicated by the instructions in this manual. • This product is waterproofed for freshwater only. If it comes into contact with salt water, immediately dry the flashlight and remove the batteries, reassemble, and rinse with freshwater. Dry thoroughly and install new batteries.
PRODUCT DIAGRAM A LED B LAMP HEAD C HEAT SINK AREA D SIDE BUTTON E LOW-VOLTAGE WARNING LED F O-RING G REMOVABLE CLIP H O-RING I TAILCAP J LANYARD EYELET A B C E D F G Also Included: H HOLSTER LANYARD SPARE O-RING USER MANUAL TWO-YEAR LIMITED WARRANTY 06 I J VULTA HURRICANE
A Note about Maximum Output When the flashlight is in High mode, the battery discharge, drive circuit, and LED will all be producing heat, and the lamp head may become extremely hot. Please be cautious when touching it. To protect the battery, circuit, and LED, and to extend the lifetime of the flashlight, we do not recommend continuously running the flashlight on High mode for more than 10 minutes. INSTALLING BATTERIES The Hurricane FG-B25 can be powered by two CR123/RCR123 (3 or 3.
OPERATION The Hurricane FG-B25 employs a side-button system to power on the flashlight and switch between the different modes. POWERING ON THE HURRICANE FG-B25 Constant On: To turn on the FG-B25, give the side button a quick press. Upon powering on, the flashlight will enter Turbo mode for 3 minutes before switching to High mode. The next time you turn on the flashlight, it will enter the most recent constant-on mode. Temporary On: To temporarily engage Turbo mode, press and hold the side button.
SETTING THE MODE Turbo/High/Medium/Low: In addition to Turbo mode, there are three constant-on modes: High, Medium, and Low. Turbo is the brightest output. When the flashlight is in Constant-On mode, press and hold the side button to cycle through the four constant-on modes in descending order of brightness. Strobe and SOS: Strobe mode continuously emits quick flashes of bright light. In SOS mode, the flashlight blinks brightly in the international Morse code distress signal pattern (· · · – – – · · ·).
hold the side button until the flashlight turns on. Locking the flashlight will not clear your current output setting. O-RING MAINTENANCE The Hurricane FG-B25’s O-rings are installed on the threaded portions to help seal out water. The O-rings are prelubricated to extend their lifetime, ensure smooth operation, and increase water resistance. If one of the O-rings dries out or there is little or no lubricant on it, we recommend applying a small amount of O-ring lubricant.
SPECIFICATIONS OUTPUT Turbo, Strobe, SOS: 620 lm High: 410 lm Medium: 130 lm Low: 20 lm BEAM INTENSITY 5,929 cd LED TYPE CREE XM-L2 POWER SOURCE Two CR123/RCR123 (3 or 3.7 V) or one 18650 (3.7 V) battery RUNTIME High: 3 hr. Medium: 10 hr. Low: 50 hr. CONSTRUCTION Body: MIL-SPEC Type III hard anodized aerospace-grade aluminum alloy Bezel: Stainless steel Lens: Tempered glass IMPACT RESISTANCE Up to 6.5´ (2 m) WATERPROOFING IPX-8 standard, up to 6.
TWO-YEAR LIMITED WARRANTY This VULTA product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of two (2) years from the original purchase date or thirty (30) days after replacement, whichever occurs later.
