User Manual

2.7 Probe Mode

There are three probe modes: AUTO, MAG and EDDY. In AUTO mode, the probe can automatically determine

the type of substrate measured. In MAG mode, the probe can only measure on magnetic substrates. In EDDY

mode, the probe can only measure on non-ferrous metal substrates. When a magnetic substrate detected, an

“F” will be shown on the right of readings, and when a non-ferrous metal detected, a “N” will be shown. User

can switch probe mode as below.

a. Press “Left Key” once to enter into menu mode(”Root” directory);

b. Press “Up Key” or “Down Key” to activate “Options” item, and press “Left Key” once to enter in;

c. Press “Up Key” or “Down Key” to activate ”Probe Mode” item, and press “Left Key” once to enter in;

d. Press “Up Key” or “Down Key” to activate your intended item, and press “Left Key” once to select the item

and go back. Press “ZERO Key” to back measure mode.

8 Storage

In general group mode(GENn), readings and statistics will be stored and not be lost when power off. In direct

group mode(DIR), readings and statistics will be lost when power off.

Each group has individual high/low limit alarm, zero calibration and multi-point calibration, user can change

these settings, and they will be stored.

In addition, user can set the system settings(e.g.: Measure Mode,Group Mode,Probe Mode etc.), these settings

will also be stored.

Note

When

battery

low, user must

replace

the

battery timely. B efore replacing

the

battery,

you need to power off

the gauge firstly.

2.9 Recall and Delete Readings

Delete the last readings(Tips: If in measure mode, press the “UP Key” once by one beep).

a. Press “Left Key” once to enter into menu mode(”Root” directory);