Installation Guide

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
FIXTURE INSTALLATION
1. Note the track head contacts, and the polarity groove running the length of the track.
2. The two contacts should be positioned so that when rotated, they will face the grooved side of the track
(this is the side with two at copper wires running it’s length).
3. Insert adapter into track slot. Pull downward on the adapter while rotating the adapter 90º.
4. Release the adapter so the locking tab seats in the track slot.
5. Removal is the reverse procedure. Track heads may be positioned anywhere along the track length.
FIXTURE INSTALLATION
Measure the length of track needed, allow for the length of the live end or other connector.
Work at oor level. Note the polarity of the track (the groove in the track indicates the two wire side).
Identify the side that accepts the live end connector.
1. Brace the opposite end of track against a solid surface. Insert the live end and secure by tightening the screw.
INSTALLATION INSTRUCTION
H Track Systems
HT2, HT4, HT6, HT8