Installation Guide

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
H Track Systems
HT2, HT4, HT6, HT8
FIELD CUTTING TRACK CONTINUED
2. Do not allow bus wires and insulation to protrude from the end and do not cut the wires and
push insulation back into the track.
3. Make a ush cut through track with a ne-toothed hacksaw. File any rough edges or ash.
Brush out any remaining lings.
4. Once the ush cut is made trim 1/4” o the end of the copper bus wire. This will allow sucient clearance for
the end cap for a mating connector. If not performed in this sequence the bus wires will be short and cause faulty contact.
5. When mating to connector already at ceiling level make sure to support connectors at both ends.