Installation Sheet

2WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
227 - LED Pendant
PD-22754
PREPARATION
1. Shut o the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a
clear area. Be careful not to lose any small parts necessary for
installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (E1) from the xture.
4. Drill holes in the ceiling aligned with the key holes located on the
mounting plate, insert the plastic anchors (C1).
5. Adjust the xture wire length by pushing the cable gripper on the
canopy and pulling the wires as desired.
6. Connect the transformer input wires with junction box wires as
shown in Fig. 2, making sure that all wire connectors (A1) are
secured. If your outlet box has a green or bare copper ground
wire, connect the xture's ground wire to it. Otherwise, connect
the xture's ground wire directly to the mounting plate using
the green screw provided. After wires are connected, tuck them
carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 2, 3, 4)
7. Secure the mounting plate to the junction box using junction box
screws (B1), fasten it to the ceiling using the wood screws (D1).
The side of the mounting plate marked "GND" must face out.
8. Connect the transformer output wire with xture wire as shown in
Fig. 2, making sure that all wire connectors (B1) are secured.
9. Place the xture over the mounting plate and secure with
mounting screws (E1).
FIG. 1
13 3/4"
11 3/4"
1 3/8"
1 3/4"
4"
Back Plate Dimensions
Wire Conector
Junction Box Screw
Cable Gripper
Lamp Body
Mounting Plate
Ground Screw
Junction Box
Plastic Anchor
Wood Screw
Mounting
Screw
Transformer
C1
D1
E1
A1
B1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring