Installation Sheet

dweLED retains the right to modify the design of our products at any time as part of the company's continuous impro
vement program. Feb 2019 2
dweLED.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTIONS
609 –LED PENDANTS
PD-60944
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
FIG. 1 WiringFIG. 3
FIG. 2
Back Plate Dimensions
Ø
8
3
/
8″
1 3/4″
1 3/8″
Ø
6 7
/
8
″
Red +
Black
-
Black - Hot
White - Neutral
Blue - Ground
Cable-gripper
Push up
Adjust the fixture wire length by
pushing the cable-gripper on
the canopy and pulling the wire
as desired.
Junction Box
Driver
Mounting Screw
A
B
C
D
Wire Connector
Plastic A nchor
Wood S crew
Junction Box Screw
Safet
y Cord
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 3)
3. Remove the mounting screw (D) from the fixture.
4. Drill holes in the wall aligned with the key holes located on the mounting plate. Insert the plastic anchor (C).
5. Secure the mounting mounting plate to the junction box using the screws provided with the junction box. Fasten the mounting plate to
the wall with the plastic anchors using the wood screws (B) provided.
NOTE: The side of the mounting plate marked “GND” must face out.
CAUTION: Hooking the safety cord to the mounting plate is recommended.
6. Adjust the fixture wire length by pushing the cable-gripper on the canopy and pulling the wire as desired.
a. Retract the wires close to the
desired length within the canopy before securing the fixture in place.
NOTE: Retracting or extending excessive cable length through the cable-gripper is not recommended.
WARNING: Shortening the cables without professional helps or electronic background is not advisable. Any modifications to the fixture
may result in voiding the warranty of the product.
CONNECTING THE WIRES (Fig. 1)
7. Connect the driver’s input wires to junction box wires as shown (Fig. 1). Make sure that all wire connectors (A) are secure. If your outlet box
has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the
mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
NOTE: This fixture features electronic low voltage (ELV or TRAIC) dimming capabilities. See notes below for specific dimming wiring
information.
COMPLETING THE INSTALLATION
9. Secure the fixture to the mounting plate using the mounting screw (B).
NOTE: DIMMING WIRING INSTRUCTIONS (Fig. 2)
10.
To utilize ELV or TRAIC dimming: use black (hot), white (neutral)
and bare copper ground wires
(ground)
s